Power Glove Gamepad Adapter

I’ve recently finished a design update to my long line of Power Glove adapters. This time with a housing and Windows 10 support! Check it out!

New Flexpoint Glove kit

Interesting that Flexpoint has just announced a USB glove kit. After all, they’ve been doing this a long time. I’m guessing these are the new sensors in the Manus VR glove? They’re dual sensor per strip…

PGLink2 board completed

Check out the updated page on my new PGLink2 board. This will allow you to connect a Nintendo Power Glove to a computer over USB. All design files are included.

Measurand ShapeHand

Check out my new Measurand ShapeHand review!!

Peregrine Glove

Check out the Peregrine glove. A next generation Pinch glove.

First new review-5DT

Just posted the first new page to the new site. This one is a 5DT glove comparison between the original 5 sensor glove and the new 5DT Ultra 5 sensor glove. 5DT Glove Comparison.

Virtual Glove Instrument (Intro Circuits Final Project)

Virtual Glove Instrument (Intro Circuits Final Project)

Power Glove

The Nintendo Power glove is an excellent device to use for low-end virtual reality system. It is a down version of the VPL Dataglove. The glove uses resistive ink bend sensors to relay to the computer…

Modified: Simple Power Glove Interface for IBM PC

Here are the schmetics for wiring the Power glove to the PC. Use +5 volt supply off of the keyboard port. Here are the pinouts on a parallel port and the Nintendo light Gun port.

Material List

Transmitter: 1- ATmega163 40 pin DIP IC 1-UHF TRX 433 MHz (Radio Shack UHF Module) 1-7805 V Regulator 1- 4Mhz Crystal 1- Red LED 1- Green LED 1- Double Row Pin Header (Firmware Upgrades) 2- 0.01uF…